About the Hold function
Posted: Fri Oct 17, 2014 1:22 am
I was playing with an apreggiator preset, 2.13 "CL Stash ARP", when I noticed that the Hold function in the Arp screen behaves a bit odd:
Switch to the Arp screen and turn the Hold encoder slowly and you will notice that Hold button LED lights up but the status on the graphical screen is still "off". If I turn the encoder yet another twist then the status message changes to "on" and the Hold function kicks in - just as if I hit the Hold button.
The same applies in the reverse, i.e., if I twist the knob slowly I will see that the status message goes to "off" (as does the Hold function) but the light above the Hold button is still lit.
Just a cosmetic issue but worth mentioning I suppose.
Switch to the Arp screen and turn the Hold encoder slowly and you will notice that Hold button LED lights up but the status on the graphical screen is still "off". If I turn the encoder yet another twist then the status message changes to "on" and the Hold function kicks in - just as if I hit the Hold button.
The same applies in the reverse, i.e., if I twist the knob slowly I will see that the status message goes to "off" (as does the Hold function) but the light above the Hold button is still lit.
Just a cosmetic issue but worth mentioning I suppose.