Right now, I had the idea to launch the delay in the FX channel 2, in order to try to have the delay in parallel. I checked if the FX channel does appear in the mixer section inputs and if it does, I could modulate this mixer input gain and this mixer channel would become my send to delay parameter. But no, it doesn't.
I think I mistaked the "insert FX post filter" with the FX channel in the Solaris Signal Path, figure 25. In fact, in that figure, it the "global effects" square that is the "channel FX" or "FXchan", right ? And the "insert FX pre OR post filter" are the same insert FX with distorse, decimator & bit chopper, is that it ?
So, there is no possible modification in the signal pass after the "global effects" square and no way to set up a 'send delay' path.
Anyway, that doesn't matter that much.
Modulating EQ gain & frequency parameter would be more important ! But that could be done, perhaps, in an easier way by adding EQ filters types in the filter list ?
I'm very sorry if all those subject have already been discussed ! (Which, I guess, have certainly been !)
